Plataforma de Movimiento Avanzada

Datos técnicos:

Longitud: 200cm
Ancho: 180cm
Alto: 45cm
Ajuste de pitch and roll: +/- 25°
Servo power: 6000-8000N
Carga soportada: 600kg
Motion Controller 500 W Helicopter / Airliner Technical Equipment
1 controlador de movimiento 230 V
2 motores eléctricos para el control de pitch y bank
1 botón de parada de emergencia
2 alimentadores para los generadores de posición
1 conexión RS232 para comunicarse con FSX/FS2004 o cualquier otro simulador open source
2 generadores de posicion para las operaciones manuales en los motores
1 indicador de corriente DC
1 interruptor para modo de movimiento normal, manual o libre
1 interruptor de calibración del modo
1 conexión remota al controlador de movimiento
1 interruptor OFF/ON
4 conexiones para transmitir Balance y Scale
3 conexiones Firmware para las actualizaciones del software (compatible para aviones y helicópteros)

Necesitarás
1 conexión 230V
1 tarjeta COM (RS232)
FS2004 or FSX

 

Descripción de nuestro partner cockpitsonic.com:

As with an authentic airliner, the entrance door lies at the rear of the cockpit. The clever construction permits a construction height of as little as 500mm which facilitates boarding.
The software for the platform offers many set-up possibilities for the individual aircraft. In this way, the inertia of a B-737 is perfectly modelled, while the agility of a Piper is also precisely felt. Our full-motion platform allows for precise configuration according to your desires. When taxiing on the runway you feel the thrust of the undercarriage and with take-off the software arranges for the sensation of lift. In a similar fashion, the simulator takes care of turns and arranges the feeling of acceleration while opening the throttle.
If the flaps and slats become extended, you feel the aerodynamic breaking action. During landings, the simulator even distinguishes between a soft touch down and a positively rough landing. Our platform is so easy to install that you do not need any specialised technical knowledge.